Wallet Liner Instructions by Collin Williams

All Leathercraft Library patterns and projects are property of Tandy Leather. Projects and patterns available are a part of the Tandy Leather Archive and may contain outdated product information or service offerings. Projects and patterns can be reproduced for personal use by printing, but Tandy Leather cannot guarantee the quality of reproduction or printing due to the image quality available. Some project and pattern themes or motifs may not be representative of Tandy Leather’s current views.


1. Cut the card slots on the interior per the pattern.
2. Using the provided guide, mark the bottom of each card slot (vertical for vertical cards and horizontal for horizontal cards) as shown

3. Using double sided tape, place a strip of tape below each card slot, above the top card slot and above the bottom slot marks as shown
4. Remove cover from tape below first card slot and place Tyvek moving towards upper slots as shown
5. Remove cover from tape and fold Tyvek down to cover.
6. Remove cover from the tape below next slot and fold Tyvek back up to the next card slot, apply tape above next guideline
7. Fold Tyvek down to cover the tape
8. Remove cover from tape under next card slot and fold Tyvek to cover tape.
9. Apply tape above next card slot mark and fold Tyvek down to cover tape
10. Remove cover from tape above next card slot and fold Tyvek to cover
11. Trim excess Tyvek from above top card slot. For vertical wallets repeat steps 7-10 until you reach the last slot